Verify transponder
With this function, it is checked whether the data of a specific barcode matches the the data of an RFID transponder. The procedure is the same as for programming, only no data is written to the transponder, but read and compared.
Procedure
The button to use this function can be set in the configuration.
By default, the lower middle button (T2) is used.
The device must be switched on.
Step 1: Scan barcode
Press and release the configured button. The yellow LED lights up and a short bright tone sounds. This means that the barcode reader is activated.
Wait until a barcode is read.
Successful Scan: A successful scan is confirmed with a short beep and a short vibration.
Failed Scan: A failed scan is signaled with three or more consecutive tones. The number of tones provides information about the reason for the error. If the scan fails, the process is aborted and can be restarted
Step 2: Scan transponder
After successfully scanning the barcode, the RFID transponder to be checked is scanned. The device must be held close to the transponder.
The verification process is started with the same button as when scanning the barcode. The process is signaled with a short bright tone and the yellow LED lights up. The RFID reader is now activated.
Successful Scan: If the data of a transponder was read successfully, the device will signal if the data matches the barcode data. If the data matches, a short beep and a short vibration will be triggered. If the data does not match, a long beep and a long vibration will be triggered.
Failed Scan: A failed scan is signaled with three or more consecutive tones. This means that no valid transponder was detected.
Error Messages
Error messages are signaled with 3 or more consecutive tones. The number of tones provides information about the reason for the error.
| Number of tones | Error |
|---|---|
| 3 | No barcode was detected or the procedure was cancelled by pressing a wrong button. |
| 4 | Failed to convert the barcode to an EPC (Missing GCP, Missing data like serial number, ...) |
| 5 | Failed to read RFID transponder |